Straight length 1000mm Exoleña Premium Exojo

Exojo Exogalva 90° Tee: 90° T-piece for branching the ventilation duct. Galvanized steel.

Exojo Exoinox SW line wind clamp: centering clamp to hold and stabilize the duct against the wind. AISI 304 stainless steel.

Exojo's Exoleña Premium anti-backdraft chimney cap: This anti-backdraft cap prevents smoke from entering the room due to wind. It is made of enamelled steel, oven-hardened at 850°C, laser-welded, and has a glossy black finish.

Exojo Exopellet 90° tee with collector: 90° tee fitting with side outlet and accessible plug for cleaning. Manufactured from enamelled steel, fired at 850°C, laser welded, with a matte black finish.

Exojo Exopellet 45° Flat Trim Plate: Flat trim plate at a 45° angle, for angled steps. Manufactured from enamelled steel, fired at 850°C, laser-welded, with a matte black finish.

Exojo Exopellet joining clamp: a safety clamp that reinforces the connection between two sections. Manufactured from steel, enamelled inside/outside at 850ºC, laser-welded, with a matte black finish.

Exojo Exopellet silicone rosette: rosette with silicone gasket for ceiling or wall installation. Manufactured from enamelled steel, oven-baked at 850ºC, laser-welded, with a matte black finish.

Exopellet ceiling light from Exojo: decorative ceiling rose/ceiling light for ceiling or wall transitions. Manufactured from enamelled steel, oven-baked at 850ºC, laser-welded, with a matte black finish.

Exojo Exoinox SW 45° Flat Trim: 45° inclined flat trim for finishing ceiling or wall outlets. AISI 304 stainless steel.

Exoleña-Exoinox DW adapter from the Exoojo Exoleña line: adapter piece for connecting Exoleña ductwork to Exoinox DW double-wall systems. Manufactured from enamelled steel, fired at 850ºC, laser-welded, with a glossy black finish.

Exojo Exogalva line anti-backflow terminal: a termination terminal that prevents backdraft. Galvanized steel.

Exojo Exogalva 45° elbow: 45° elbow for changing the direction of the ventilation duct. Galvanized steel.

Exojo Exoinox SW 90° Tee: 90° T-piece for diverting the flue gas exhaust duct. AISI 316L stainless steel, laser welded.

Exojo Exopellet Inox 316L wall-mounted bracket: wall bracket for securing the duct to the wall. Made of AISI 316L stainless steel, laser-welded.

Exojo Exopellet line screw-on wall bracket: wall bracket for fixing the duct to the wall. Made of enamelled steel, fired at 850ºC, laser-welded, with a matte black finish.

Exojo Exopellet Inox 316L Straight Module 500mm: straight section of flue gas exhaust duct. Manufactured in AISI 316L stainless steel, laser welded.