Horizontal discharge terminal Exopellet Exojo

Exojo Exoinox SW 45° Flat Trim: 45° inclined flat trim for finishing ceiling or wall outlets. AISI 304 stainless steel.

Exojo Exogalva 90° Tee: 90° T-piece for branching the ventilation duct. Galvanized steel.

Exojo's Exoleña Premium 135° Tee: 135° tee fitting with angled side outlet. Manufactured from enamelled steel, fired at 850°C, laser welded, with a glossy black finish.

Exojo Exoleña 45° Elbow: 45° elbow for changes of direction in installation. Manufactured from enamelled steel, fired at 850°C, laser welded, with a glossy black finish.

Exojo Exopellet Inox 316L rain collar: a cap-type roof collar for roof openings. Made of AISI 316L stainless steel, laser-welded.

Exojo's Exoleña Premium MM coupling: a male-to-male coupling for joining two sections. Manufactured from enamelled steel, fired at 850ºC, laser-welded, with a glossy black finish.

Exojo Exopellet anti-backdraft terminal: This anti-backdraft cap prevents smoke from escaping due to wind. It is manufactured from enamelled steel, oven-hardened at 850°C, laser-welded, and has a matte black finish.

Exojo Exoleña 1000mm straight module: straight section of flue gas exhaust duct. Manufactured in enamelled steel, inside/outside, at 850ºC, laser welded, with a glossy black finish.

Lead roofing sheet 5°-30° from the Exoinox SW line by Exojo: lead roofing sheet for roofs with a slope of 5° to 30°. Lead.

Exojo Exopellet 90° elbow: 90° elbow for right-angle changes of direction. Manufactured from enamelled steel, fired at 850°C, laser-welded, with a matte black finish.

Exojo Exogalva line collector: closing plug for the lower end of the system. Galvanized steel.

Exojo Exoinox SW 45° elbow: 45° elbow for changes of direction in installation. Manufactured from AISI 316L stainless steel, laser welded.

Exojo Exopellet silicone rosette: rosette with silicone gasket for ceiling or wall installation. Manufactured from enamelled steel, oven-baked at 850ºC, laser-welded, with a matte black finish.

Exojo Exoinox SW flat trim: flat trim to cover the opening of the duct. AISI 304 stainless steel.

Exojo's Exoleña Premium line anti-condensation starter module: This starter module features an anti-condensation chamber to prevent condensate dripping during flue start-up. It is manufactured from enamelled steel, fired at 850°C, laser-welded, and finished with a glossy black coating.

Exojo Premium Line Collector: Bottom-closing plug/collector for the pipe, accessible for cleaning. Manufactured from enamelled steel, fired at 850ºC, laser-welded, with a glossy black finish.