Silicone seal Exopellet Inox 316L Exojo

Exojo Exopellet 45° Flat Trim Plate: Flat trim plate at a 45° angle, for angled steps. Manufactured from enamelled steel, fired at 850°C, laser-welded, with a matte black finish.

Exojo Exoleña line ceiling light: decorative ceiling rose/ceiling light for ceiling or wall transitions. Manufactured from enamelled steel, oven-baked at 850ºC, laser-welded, with a glossy black finish.

Exojo's Exoleña Premium 135° Tee: 135° tee fitting with angled side outlet. Manufactured from enamelled steel, fired at 850°C, laser welded, with a glossy black finish.

Exojo Exoinox SW 30° Elbow: 30° elbow for smooth changes of direction during installation. Made of AISI 316L stainless steel, laser welded.

Exojo Exogalva line collector: closing plug for the lower end of the system. Galvanized steel.

Exojo's Exoleña Premium 45° elbow: a 45° elbow for changes in direction during installation. Manufactured from enamelled steel, fired at 850°C, laser-welded, with a glossy black finish.

Exojo Exogalva line 1000mm straight module with regulator: 1000mm straight section of ventilation duct with flow regulator (0.5mm thick). Galvanized steel.

Exogalva line reducer from Exojo: a reducer for connecting one pipe to another of smaller diameter. Galvanized steel.

Exojo Exopellet telescopic roof trim: a telescopic trim set with a rosette for the roof opening. Manufactured from enamelled steel, oven-baked at 850°C, laser-welded, with a matte black finish.

Exojo Exoinox SW flat trim: flat trim to cover the opening of the duct. AISI 304 stainless steel.

Exojo Exopellet silicone collector: sealing cap with silicone gasket. Made of enamelled steel, inside/outside, fired at 850ºC, laser welded, with a matte black finish.

Exojo Exoinox SW 90° Tee: 90° T-piece for diverting the flue gas exhaust duct. AISI 316L stainless steel, laser welded.

Exojo Exoleña 45° Elbow: Flexible 45° wavy elbow for small changes of direction. Manufactured from enamelled steel, fired at 850°C, laser-welded, with a glossy black finish.

Exojo Exopellet MM coupling sleeve: male-to-male coupling sleeve for joining two sections. Manufactured from enamelled steel, fired at 850ºC, laser-welded, with a matte black finish.

Exojo Exopellet Inox 316L MM coupling sleeve: male-to-male coupling sleeve for joining two sections. Made of AISI 316L stainless steel, laser welded.

Exojo Exogalva 90° Tee: 90° T-piece for branching the ventilation duct. Galvanized steel.